MacDon D50, Operator'S Manual

Page: 98 / 298

169441
86
Revision D
1004225
A
Figure 3.82: Wide Deflector
6. Drill out seven pop-rivets (A) along the endsheet and
remove deflector (B).
7. Locate new deflector (B) onto the endsheet bracket and
attach with seven pop-rivets (MD #18768) (A).
1004224
A
B
Figure 3.83: Narrow Deflector
8. Position new deflector (MD #172381) (A) onto the endsheet
bracket and attach with seven pop-rivets (MD #18768) (B).
9. Reinstall three screws at the aft end of the deflector.
3.16.2 Reworking Draper Deflectors
If the draper deflectors are too wide, they can be trimmed to narrow them.
To trim the deflectors, follow these steps:
DANGER
To prevent bodily injury or death from the unexpected start-up of the machine, always stop the engine and remove the
key from the ignition before making adjustments to the machine.
WARNING
To prevent bodily injury from the fall of a raised reel, always engage the reel safety props before going under the
raised reel for any reason.
1. Raise the reel fully.
2. Lower the header fully.
3. Shut down the engine, and remove the key from the ignition.
4. Engage the reel safety props. For instructions, refer to 3.10.1 Engaging Reel Safety Props, page 36 .
OPERATION