Checking and Adjusting Endshields
Endshields are subject to expansion or contraction caused by large temperature variations. The position of the top
pin and lower latch can be adjusted to compensate for dimensional changes.
1. Check gap (X) between front end of shields and header
frame and compare to the values in Table
Gap at Various Temperatures, page 34
.
Table 3.1 Endshield Gap at Various Temperatures
Temperature in Degrees
°C (°F)
Gap (X) in
mm (in.)
7 (45)
13–18 (1/2 – 23/32)
18 (65)
10–15 (3/8 – 19/32)
29 (85)
7–12 (9/32 – 15/32)
41 (105)
4–9 (5/32 – 11/32)
NOTE:
If adjustment is required, follow these steps:
Figure 3.14: Gap between Endshield and
Header Frame
2. Loosen the four bolts (A) on the support tube
bracket (B).
Figure 3.15: LH Endshield Support Tube
214044
34
Revision A