6. Loosen the two lock nuts (A) on the deck support (B)
one-half turn only
.
NOTE:
The number of deck supports (B) is determined
by the header size: four on single reels, and
eight on double reels.
7. Tap the deck (C) to lower the deck relative to the deck
supports. Tap the deck support (B) using a punch to
raise the deck relative to the deck supports.
Figure 5.119: Deck Support
8. Adjust deck (A) to 1 mm (0.04 in.) add the draper
thickness as measured in Step
below (B)
cutterbar (C) to create a seal.
9. Tighten deck support hardware (D).
10. Recheck gap (B). Refer to Step
.
11. Tension the draper. Refer to
.
Figure 5.120: Deck Support
12. Adjust the backsheet de
fl
ector (A) (if required) by
loosening nut (D) and moving the de
fl
ector until there
is a 1–7 mm (1/32–5/16 in.) gap (C) between the
draper (B) and the de
fl
ector.
Figure 5.121: Backsheet Deflector
214044
162
Revision A