1. Start the engine, raise the header, and raise the reel.
2. Stop the engine, and remove the key from the ignition.
3. Loosen the draper by turning the adjuster bolt (A)
counterclockwise.
Figure 5.132: Tensioner
4. Remove the tube connectors (B), screws (A), and nuts
from the draper joint to uncouple the draper.
5. Pull the draper off the drive roller.
Figure 5.133: Draper Connector
6. Align the setscrews with the hole (A) in the guard.
Remove the two setscrews holding the motor onto the
drive roller.
NOTE:
The setscrews are 1/4 turn apart.
7. Remove the four bolts (B) securing the motor to the
drive roller arm.
NOTE:
It may be necessary to remove the plastic
shield (C) to gain access to the top bolt.
Figure 5.134: Drive Roller
214044
167
Revision A