4. Mark the hydraulic lines (A) and their locations in the
motor (B) to ensure correct reinstallation.
5. Disconnect the hydraulic lines (A) at the motor (B). Cap
or plug open ports and lines.
6. Remove four nuts and bolts (C), and remove the
motor (A). Retrieve the spacer (if installed) from
between the motor (B) and the motor mount.
7. If motor is being replaced, remove hydraulic
fi
ttings
from old motor and install in new motor using the same
orientation. Refer to
for
fi
tting
installation guidelines.
Figure 5.231: Reel Motor and Hoses
Installing Reel Drive Motor
1. Slide the motor mount (A) up or down so the motor
mounting holes (B) are accessible through the
openings in the chain case.
Figure 5.232: Reel Drive Motor Mounting Holes
2. Attach the motor (A) (and spacer if previously removed)
to the motor mount (B) with four 1/2 x 1-3/4 in.
countersunk bolts and nuts (C).
3. Torque nuts (C) to 73 N
·
m (54 ft·lbf).
4. If installing a new motor, install the hydraulic
fi
ttings
(not shown) from the original motor and torque to
110–120 N
·
m (81–89 ft
·
lbf).
Figure 5.233: Reel Drive Motor
214044
207
Revision A