1. Shut down the windrower, and remove the key from
the ignition.
2. Stroke the knife as required to center the knife
section (A) between the guards (E).
3. Remove nuts (B).
4. Remove bars (C) and lift the knife section off the
knife bar.
5. Remove the splice bar (D) if knife section is under
the bar.
6. Clean dirt off the knife back, and position the new knife
section onto the knife back.
7. Reposition bars (C) and/or (D) and install the nuts (B).
NOTE:
If replacing screws, ensure they are fully inserted.
Do not use nuts to draw screws into the knife bar.
8. Torque nuts to 9.5 N·m (7 ft·lbf).
Figure 5.20: Cutterbar
Figure 5.21: Cutterbar
214044
117
Revision A