NOTE:
Use a pair of modi
fi
ed channel lock pliers (A) to install
bushing clamps (C). Secure pliers in a vice and grind
a notch (B) into the end of each arm to
fi
t the clamp
as shown.
Figure 5.183: Modified Pliers
Cam end bushings
1. Position the bushing halves (B) on the tine tube with
the
fl
angeless end adjacent to the reel arm, and
position the lug in each bushing half into the hole in
the tine tube.
2. Slide the tine tube (A) towards the tail end of the reel to
insert the bushing (B) into the reel arm. If the tine tube
supports are installed, ensure the bushings at those
locations slide into the support.
3. Reinstall the previously removed
fi
ngers or tines. Refer
to the following procedures as necessary:
•
Removing Plastic Fingers, page 181
•
Removing Steel Fingers, page 180
Figure 5.184: Cam End
4. Install the bushing clamp (A) onto the tine tube adjacent
to the
fl
angeless end of the bushing (B).
5. Position the clamp (A) on the bushing (B) so the edges
of the clamp and bushing are
fl
ush when the clamp
is
fi
t into the groove on the bushing and the lock tabs
are engaged.
Figure 5.185: Bushing
214044
188
Revision A