MS-TestPro
User’s Manual
Page 16 of 113
4.
Operating the Touchscreen
4.1
Test Setup
This section describes the physical setup and connectivity schemes used to perform tests using MS-
TestPro.
◼
Testing MS-TestPro Modules
◼
Connection to System Under Test (SUT)
IMPORTANT
* Make sure that you complete all cable connections
before
powering up the MS-TestPro test device.
* Always power down the unit for cartridge replacement.
4.1.1
MS-TestPro Test Setup
In the MS-TestPro Modules test setup mode, the transmitter and receiver modules of the MS-
TestPro device are directly connected to each other using a CATx cable of up to 100 meters (328
feet) in length, as shown in Figure 11 and Figure 12 below.
Figure 11: MS-TestPro Modules Test Setup using External Pattern Generator
HDBaseT
HDMI
H
D
M
I
External
Pattern
Generator
