Lyngdorf Audio MP-60 – Owner’s manual
7
Home Automation System Integration
The MP-60 is compatible with home automation systems via the RS232 and network connector on the rear
socket panel. The MP-60’s IR and trigger connections can also be programmed for use in a home
automation system.
IP Control
Connect the MP-60 to your local network and access the MP-60 by going to
http://mp60.local
in your
browser.
Pressing the OK button on the remote and toggling through the information, you will see the IP address
allocated to the MP-60.
Open a TCP connection on port 84 and use the same protocol as on the serial interface. Use Telnet, Putty,
or a similar program to open the TCP connection.
If you do not know the IP address of the MP-60 on your local network, the MP-60 supports Apple´s Bonjour
Discovery service, which must be on the computer with which you wish to set up the MP-60. The software is
built-in as part of the Apple OS X operating system (not iOS devices). For Windows operating systems, the
software can be found at http://www.apple.com/support/bonjour/
Preparing for Mounting in a Rack
The MP-60 processor is equipped from the factory with feet for free-standing placement.
To install the MP-60 in a rack:
1. Turn the MP-60 upside-down and place it on a stable, even surface.
2. The screws used to fasten the rack brackets to the bottom of the MP-60 are in the holes designated
for the brackets when the product leaves the factory.
3. Fasten the brackets for rack mounting to the MP-60.
4. If so required, the feet can be removed
5. Mount the MP-60 in a rack.
Note: A rack mount kit is available for achieving a cleaner 4U
rack-size (item # 900008201)
