Lyngdorf Audio MP-60 – Owner’s manual
10
How to Pair Remote Control in RF Mode
The MP-60 remote has both an IR and RF mode, and is by default set to IR.
To pair the RF remote control to the MP-60:
1. Turn on the MP-60.
2. Hold down Play/Pause and OK until the remote control´s green LED flashes.
3. Release the buttons.
4. Point the remote control at the MP-60 and hold it within 30cm / 1 foot of the front panel; when the
green LED stops blinking, the remote is connected.
5. The remote is now RF paired to the MP-60.
To reset the pairing of the remote control, press Back and OK until the red LED flashes twice.
Switching Remote Between RF and IR Mode
To switch the remote from IR to RF mode, hold down OK and 2. The LED will flash green twice.
To switch the remote from RF to IR mode, hold down OK and 1. The LED will flash red twice.
If you press a button on the remote and the red LED at the top turns on, then you are in
IR mode. If it turns green you are in RF mode.
