XENON LAMP REPLACEMENT
Warnings:
Disconnect the light source from main power and allow the equipment to cool before handling the
Xenon lamp. Use protective eye, face, and hand equipment when handling the Xenon lamp.
Please
know that Xenon lamps have been known to explode. The chance of this happening when the lamp is
handled properly is very low. The chance of injury if the lamp should explode are very high if the
proper precautions are not taken. The chance of a lamp failure while the light source is not in
operation is very rare. Each lamp is tested thoroughly during manufacture to ensure against failure.
Figure 7
Figure 6
Retaining clips (locked)
Replace lamp when illumination is no longer satisfactory or sufficient for use.
To remove the lamp:
1. Make sure the main power on/off switch is turned off. Disconnect the power cord.
2. Allow the unit to cool down for a minimum of 15 minutes before replacing the lamp. The lamp may represent a
burn hazard if not allowed to cool sufficiently prior to servicing the unit.
3. Remove the retaining screw located at the back of the at the CLX. See Figure 3.
4. Slide the top cover of the CLX towards the back of the unit. Do not slide the cover off completely, rather just
enough to remove and replace the lamp. See Figure 6.
5. Unlock the lamp retaining clips holding the lamp in the CLX. Grasp and pull the lamp straight up. See Figure 7.
- 5 -
