OPTIONAL FLOOR STAND INSTALLATION
Figure 8
Power cord
hanger
Upper column
Lower column
Caster base
Figure 9
There are four (4) parts to the floor stand
assembly: See Figure 8.
1. Caster base
2. Two-piece column
3. Light source base with cable hangers
4. Handle
Floor stand assembly instructions:
1.
Assemble the column. Note arrow on the
lower column must point up. Slide the
upper column over the arrow end of the
lower column. Seat firmly.
2.
Insert assembled column into base. Seat
firmly.
3.
With the handle screw positioned at the
top of the handle, slide the handle onto the
upper column so there is about 5 inches
(13 cm) of space between the handle and
the top of the column. Tighten handle
screw to hold in place.
4.
Fully insert post of the CLX base plate into
plastic bushing on top of upper column.
Rotate base plate until fingers in the
bushing engage slots at the bottom of the
post.
5.
Loosen handle screw and position handle
opposite power cord hanger. Adjust
height as preferred by user, and firmly
secure handle screw.
6.
Secure CLX to base plate by aligning
mounting screws to screws holes on
bottom surface of CLX and tighten. See
Figure 9.
Handle
Mounting screws
CLX base
plate
Handle screw
- 7 -
