User Guide
- 29
–
11.3 Radiometer RS-232 Phono Connector: Signal Descriptions
11.3.1
The side front panel RS-232 stereo phono connector is labell
ed “Radiometer”.
This connector is used to connect S2000 to the R2000 Radiometer for
calibration and setup purposes. It is a RS-232 connector dedicated to
communication with the R2000 Radiometer.
PIN NO
SIGNAL NAME
1 (Shield)
GND
2 (Ring)
Tx
3 (Tip)
Rx
Table 4 RS-232 Phono-Connector Pin-Out
11.4 Audio Style Foot Pedal Connector: Signal Descriptions
11.4.1
The rear panel foot pedal connector, a 3 mm audio style jack, has the following
pin-out:
Connection Point
SIGNAL NAME
Outer Rim
Positive input, active low
Center Pin
Common ground (GND)
Table 5 Foot Pedal Pin-Out
11.4.2
This is a simple 2-wire, audio style jack that can be connected to a foot pedal
(supplied with each unit) or any other electro-mechanical triggering device. This
is an exposure trigger input used to start an exposure. The shutter activation
input and front panel START/STOP button will also trigger the shutter.
12 Viewing the Accumulated Lamp Hours
12.1.1
Your S2000 system automatically accumulates the number of hours that the
lamp is on and shows this information on the LED display. The lamp hours are
shown when the unit is in Lamp Hour mode.
12.1.2
Set your S2000 to Lamp Hour Mode by pressing the Mode button until the “L
HRS” LED on the front panel is illuminated. The LED display will indicate four
digits with a flashing “.” (decimal) located to the right of the furthest right digit.
This shows the accumulated number of hours the lamp has been on. (XXXX.)
Note
: Pressing the start/stop button while in Lamp Hour mode will open
the shutter for the set Exposure Time.
