Lumag RAMBO-HC15PRO, Original Operation Manual

Page: 26 / 38

26
16.3 Lubricants
IMPORTANT NOTICE!
Fuels and lubricants used must comply with the
operating material regulations of the operator and
the stated specification, consult the supplier if
necessary.
Fuel Assembly Specification Filling
quantity
Fuel Engine Gasoline
ROZ95 or
higher 6.5 litres
Engine oil Engine 10W-30 or
10-W-40 1.1 litres
Grease Lubrication Multi-purpose
grease with EP
properties
KP2K-20
1-2 stroke
(grease gun)
Operating material specification
16.3.1 Greasing the blade chassis
Lubricate the bearings of the blade drum on both
sides at the two grease nipples (1+2) with a grease
gun
before each use and / or after 5-10 operating
hours and after each cleaning .
The 2nd grease nipple is located behind the V-belt
protection.
1.
Loosen the 4 fastening screws on the belt
cladding and remove the cover.
2. Clean the grease nipples with a rag.
3. Apply the grease gun to all nipples one after
the other and pump in grease.
4. Wipe away any excess grease.
WARNING!
After lubrication, the V-belt protection must be
properly refitted.
16.2.2 Greasing the oscillating axle
There is a grease nipple (3) on the oscillating axle.
Lubricate the axle, as required, with a
commercially available multi-purpose grease!
Lubrication points blade chassis, oscillating axle
16.3.3 Changing the engine oil
IMPORTANT NOTICE!
The engine oil must be changed after the first 5
hours of operation.
Change the engine oil when the engine is warm (oil
then drains quickly and completely). Disposal
according to environmental regulations.
Assembly Number Interval
(OH*)
Quantity
Engine oil change -
initial commissioning 1 5 1.1 litres
Engine oil change
operation
*or 1 x per season 1 50* 1.1 litres
* Operating hours
To change the oil:
1. Unscrew the oil drain bolt
2. Hold a suitable container (at least 2.5 litres)
under the oil drain bolt
3. Tilt the machine with a 2nd person so that the
oil drains off
4. Thoroughly clean the area around the oil
outlet port
5. Screw in the oil drain bolt again
6. Slowly fill 1.1 litres of engine oil into the oil
filler bolt
7. Tighten the oil filler bolt
8. Remove oil residues and / or contamination
9.
E
ngine oil must be disposed of in an
environmentally friendly manner in accordance
with local regulations