27
Oil change, upper and lower level
ATTENTION!
Observe oil level. Do not operate the engine with
too much or too little engine oil.
See also... Fig. Oil
change, upper and lower level.
16.4
Blades
Blades are blunt when
–
the shredding noise sounds ponderous.
–
the
shredding
speed
has
decreased
considerably.
–
the drive belts slip despite tension.
After approx. 30-50 hours of operation, the
cutting edges of the blades are blunted under
normal operating conditions.
The two drum blades have two cutting edges and
can therefore be turned once.
The fixed counter blade can be turned once.
Adjust the counter knife to a cutting gap of 0.5 mm
using a thickness gauge. Then tighten the fixing
screws with 60 Nm and medium thread locking
adhesive.
Blade chassis
Blunted blades can be turned over. Damaged
blades (cracked, chipped, severely bent or
otherwise
damaged)
must
be
replaced
immediately.
DANGER!
The machine must not be put into operation if the
blades are not fully inserted!
The original designs of the manufacturer must be
used for all spare parts.
16.5
Drive belt
IMPORTANT NOTICE!
Check the condition of both drive belts before each
commissioning. Drive belts must be pre-tensioned
in such a way that they can be pushed through
approx. 8-10 mm in the middle using thumb
pressure.
When changing the belt, both drive belts must
always be changed.
Installed drive belts: 2 pieces
16.5.1 Check drive belt for wear and tension
To check the drive belts:
1.
Remove belt cover
2.
If the drive belts show wear, both must be
replaced
See also... Replacing / tightening the drive belt
(16.2.2)
Summary of Contents for RAMBO-HC15PRO
Page 37: ...37...
