Lumag RAMBO-HC15PRO, Original Operation Manual

Page: 13 / 38

13
8. Functions
8.1 Engine
Engine switch (main switch) = Ignition switch on
E-start (1)
The engine switch in the OFF position prevents the
machine (engine) from starting. To restart the
engine, move the engine switch to the ON position,
then start the engine as described in
COMMISSIONING / start process (14.2) .
Recoil starter, rope starter (2+3)
The starter is designed as a magneto ignition with
spring reset. Incorrect handling of the recoil starter
can damage the starter. Never wrap the recoil
from the recoil starter around your hand.
Choke valve (4)
The choke valve opens and closes the choke flap of
the carburettor. The choke valve is only used to
start a cold engine.
Fuel switch (5)
The fuel switch opens and closes the connection
between the tank and the carburettor.
Air filter (6)
The air filter consists of a foam pre-filter and a
paper filter insert. It is located under the cover (6).
A dirty air filter is noticeable by unclean running of
the engine and black smoke.
Muffler (7)
The engine exhaust gets warm when the engine is
running. Avoid touching the muffler when it is hot.
Caution: Danger of burns!
Throttle lever (8)
The throttle can be reduced with the lever on the
engine so that the engine idles and the blade drum
stops.
Spark plug, spark plug connector (9)
Ignition takes place via an ignition cable and a
spark plug connector, which is connected to the
spark plug. Before starting the engine, check the
spark plug connector for proper seating. Always
disconnect the spark plug connector from the
spark plug during adjustment and maintenance
work.
Oil filler bolt with dipstick (10)
The engine oil is filled into the receptacle for the oil
dipstick. DO NOT screw the dipstick down to check
the oil level.
Oil drain bolt (11)
The oil drain bolt is located at the rear of the
engine.
Fuel tank (12)
There is a fuel switch under the tank.
Centrifugal clutch
The engine has a centrifugal clutch coupled to the
crankshaft. When the engine speed increases, the
drive of the blade drum is automatically engaged.
8.2 Device unit
Safety circuit
EMERGENCY STOP bar (10) on the infeed chute
The engine can be stopped in dangerous situations
by pressing the EMERGENCY STOP bracket (10).
There is another switch with the same function.
−
Engine switch (ignition switch) (1) on the
engine.
WARNING!
The blade drum trails for a short time due to the
flywheel mass!
In case of unexpected circumstances, never
hesitate to operate the EMERGENCY STOP bar
(10) on the infeed chute.
Adjustable deflector (1)
The throwing range and throwing direction of the
shredded material can be changed by adjusting the
flap on the ejection chute.
Foldable infeed chute (9)
The infeed chute can be folded to the side for
cleaning the blade drum, removing blockages and
changing the blades.
DANGER!
Before commissioning of the machine, the infeed
chute as well as the safety circuit must be
refitted. Check the function of the safety circuit!