Lumag RAMBO-HC15PRO, Original Operation Manual

Page: 23 / 38

23
Always keep hands away from infeed and ejection
openings!
Branches up to Ø 150 mm, twigs, bushes or green
waste can be shredded.
WARNING!
Once the motor is running, the blades move and
anything fed into the chute will inevitably be
shredded.
Put shredded material (branches, twigs, etc.) into
the infeed chute. When the machine grabs the
branches, let go of the shredded material
immediately. The branches are fed it by
themselves (automatic infeed). Insert thick
branches in a dosed manner! Ensure that the
engine speed is maintained.
First cut off side branches of more than 3 cm and
insert them separately.
Shredded material protruding from the machine
can knock around when being fed into the
machine. Therefore, keep a sufficient safety
distance from the machine.
IMPORTANT NOTICE!
The hardness of the branches to be shredded
depends, among other things, on the type of wood,
the time between cutting and shredding as well as
the dryness of the branches. Optimal results are
achieved when the branches are shredded shortly
after cutting.
–
Thin and long bushes and / or branches are
pulled in very quickly. For this reason, let go of
this shredded material quite quickly.
– Process highly water-containing shredded
material alternately with woody material to
avoid blockage in the machine.
– The cutting unit draws in the shredded
material largely independently.
– Observe the maximum branch diameter to be
processed.
See also... TECHNICAL DATA (9.)
– Depending on the type and freshness, the
maximum branch diameter may be reduced.
– If the cutting unit is blocked, switch off the
engine immediately to avoid overloading the
engine. Remove spark plug connector and
eliminate fault!
In case of unexpected circumstances, never
hesitate to operate the safety bar (EMERGENCY
STOP) (10) on the infeed chute.
The safety bar (EMERGENCY STOP) (10) may only
be operated in an emergency. To shut down the
machine normally, first allow the engine to
continue idling and then switch it off and secure it
against restarting.
To do this, set the motor switch
(1) to OFF. See also... COMMISSIONING / Switching
off the engine (15.3)
When you stop shredding, give the machine
enough time to “spin clean”. This prevents starting
problems during the next shredding.