Lucent Technologies Stinger, Administration Manual

Page: 68 / 374

2-6 Stinger® Administration Guide
Working with Stinger Shelves and Modules
Viewing system components
contact-closure[ n ] An array of indexed parameters that indicate the
contact closure state (
yes if contact closure is detected)
on the corresponding remote shelf. Only the first two
contact closure values are meaningful for Stinger MRT units.
host-port:physical-
address Physical address of the remote shelf. The address
specifies a shelf ID, followed by a slot number, followed
by the item number of an addressable entity within the
context of shelf and slot.
Not meaningful for Stinger CR units.
host-port:logical-item Number that specifies an addressable logical entity
within the context of a physical address.
Not meaningful for Stinger CR units.
topology:port-towards-
host-shelf Port on the remote shelf used for the link to the host.
Not meaningful for Stinger CR units.
topology:port-1-shelf Shelf ID of the remote shelf directly connected to the
first cascade port on the host.
Not meaningful for Stinger CR units.
topology:port-2-shelf Shelf ID of the remote shelf directly connected to the
second cascade port on the host.
Not meaningful for Stinger CR units.
validation-status:id-
valid Indicates whether the validation-id setting in the
remote-shelf-config profile matches the validation ID
specified by the remote shelf’s DIP-switch setting. The
disabled value indicates that no validation was
performed. A true setting indicates that validation was
done, and the software validation ID setting matched
the DIP switch setting. A
false setting indicates that
validation was done, and the software validation ID
setting did not match the DIP switch setting.
Not meaningful for Stinger MRT units.
validation-status:
validation-id-setting Physical validation ID set by DIP switches on the
remote shelf (from 0 to 255). This value is read from
the remote shelf.
Not meaningful for Stinger MRT units.
validation-status:
validation-id
The validation ID specified in the remote-shelf-config
profile. This value is compared against the validation-
id- setting from the remote shelf to determine the
validation result, which is shown in the id-valid field.
Not meaningful for Stinger MRT units.
Parameter Setting