Lucent Technologies Stinger, Administration Manual

Page: 248 / 374

10-12 Stinger® Administration Guide
Monitoring OSPF routing
Displaying OSPF interfaces
The fields in the output contain the following information:
Displaying OSPF interfaces
To display summarized information about all OSPF interfaces or specific information
about a single interface, include the
intf option with the ospf command.
Displaying summarized information
To display summarized information on OSPF interfaces, enter the following
command:
admin> ospf intf
Ifc Address Phys Assoc. Area Type State #nbrs #adjs DInt
10.103.0.254 ie0 0.0.0.0 Brdcst DR 0 0 40
10.105.0.254 ie1-7-1 0.0.0.0 Brdcst Other 9 1 40
100.103.100.254 ie1-7-4 0.0.0.0 Brdcst Other 2 2 40
50.151.0.2 apx1 0.0.0.0 P-P P-P 0 0 120
10.103.0.254 m2 0.0.0.0 P-P P-P 1 1 120
10.103.0.254 m1 0.0.0.0 P-P P-P
1 1 120
The fields in the output contain the following information:
Field Specifies
DType Internal route type. DType displays one of the following values:
RTE (generic route), ASBR (AS border route), or BR (area
border route).
RType Internal router type.
Destination Router’s IP address.
Area Area in which the router resides.
Cost Cost of the router.
Next hop(s) Next hop in the route to the destination.
IfNum Number of the interface used to reach the destination.
Field Setting
Ifc Address
Address assigned to the Stinger unit’s Ethernet interface. To
identify WAN links, use the
Type
and
Cost
fields.
Phys
Name of the interface or the
connection
profile for WAN links.
Assoc. Area
Area in which the interface resides.
Type
Point-to-point (P-P) or Broadcast (Brdcst). WAN links are point-
to-point links.
State
State of the link according to RFC 2328. There are many
possible states, and not all states apply to all interfaces.
#nbrs
Number of neighbors of the interface.