Lucent Technologies Stinger, Administration Manual

Page: 275 / 374

Monitoring ATM and PNNI
Monitoring PNNI nodes
Stinger® Administration Guide 11-23
transmitted 121 Hello packets, but has received no information from the remote
node.
admin> pnnilinkdisplay -d 1 801
Node PortId PhysicalAddr IntfIndex LinkType HelloState
1 801 {1 17 1} 11 Unknown Attempt
RemoteNodeId
00:00:00:00:00:00:00:00:00:00:00:00:00:00:00:00:00:00:00:00:00:00
RemotePortId DerAggrToken SvccRccIndex RcvHellos XmtHellos
0 0 0 0 121
UpnodeId
00:00:00:00:00:00:00:00:00:00:00:00:00:00:00:00:00:00:00:00:00:00
UpnodeAtmAddress
00:00:00:00:00:00:00:00:00:00:00:00:00:00:00:00:00:00:00:00:00:00
CommonPeerGroupId LinkVersion
00:00:00:00:00:00:00:00:00:00:00:00:00:00 1
Field Indicates
Node
PNNI node index. Only node index 1 is currently supported.
PortId
Dedicated (nailed) group number associated with the
physical port. The node index (1) and port ID identify the
interface to which the link is attached.
PhysicalAddr
Physical address of the trunk port in the following format:
{ shelf-n slot-n item-n }
IntIndex
Entry number in the interface table for the interface to
which the logical link corresponds. The value is valid only
for LinkType values of Unknown, Lowest Level Horizontal
Link, and Lowest Level Outside Link. All other link types
display a zero value.
LinkType
Type of logical link. Possible types are Unknown, Lowest
Level Horizontal Link, Horizontal link to/from LGN, Lowest
Level Outside Link, Uplink, and Outside link and Uplink.
(An
uplink is a link to a higher-level node.)
HelloState
State of the Hello protocol exchange across the link or the
state of the corresponding logical group node (LGN)
horizontal link Hello exchange. For uplinks, the field
displays NA. Other link types have the following valid
values: NA, Down, Attempt, Oneway Inside, Twoway
Inside, Oneway Outside, Twoway Outside, and Common
Outside.
RemoteNodeId
Node ID of the neighboring node on the other end of the
link. The value is valid only for LinkType values of Lowest
Level Outside Link or Uplink. If the node at the other end of
an uplink (
upnode ) has not yet been identified, or if the
LinkType is Lowest Level Horizontal Link, the field displays
zero.