Lucent Technologies Stinger, Administration Manual

Page: 300 / 374

12-12 Stinger® Administration Guide
Diagnostic Testing
OAM testing
The following command stops the preceding test:
admin> oam -C 17 2 0 35 e -
To instruct the Stinger unit to perform an F5 segment continuity test from a T1000
module in slot 3, over VCI 36, proceed as follows:
admin> open 1 3
t1000-1/3> oam -c 3 0 36 s +
Sending OAM continuity activation cell
The following command stops the preceding test:
t1000-1-1/3> oam -c 3 0 36 s -
Sending OAM continuity deactivation cell
Running F5 continuity tests using the
atm-oam
profile
The following sample commands start an F5 continuity check on slot 15, port 2,
VPI 3 and VCI 40:
admin> new atm-oam {{ 1 15 2} 3 40}
ATM-OAM/{{ 1 15 2} 3 40} read
admin> set continuity-config enabled = yes
admin> set continuity-config continuity-level = end-to-end
admin> write
ATM-OAM/{{ 1 15 2} 3 40} written
To disable the preceding continuity check, enter the following commands:
admin> new atm-oam {{ 1 15 2} 3 40}
ATM-OAM/{{ 1 15 2} 3 40} read
admin> set continuity-config enabled = no
admin> write
ATM-OAM/{{ 1 15 2} 3 40} written
OAM loopback tests
You run can use the oam -L | l command or set the parameters in the atm-oam profile
and its loopback-config subprofile to run an F4 or F5 OAM loopback test.
Running F4 and F5 loopback tests using the
oam
command
To run a loopback test from the control module, use the following syntax:
oam -L slot port vpi |- l slot port vpi [ vci ] e | s cell-count
You can also run a loopback test from a LIM by first opening a session with the LIM.
When you run a loopback test from a LIM, the
slot option no longer applies.
For example, to send 64 consecutive segment OAM F4 loopback cells to VPI 15 on
DSL port 2, issue the following command from a trunk module or LIM:
admin> oam -L 2 15 s 64
To display additional information about the outgoing and incoming segment test
cells, use the following command:
admin> oam -p