Lucent Technologies PacketStar PSAX, User Manual, Page: 174 / 405

255-700-243 4-101
PacketStar
®
PSAX 12-Port Medium-Density DS1 Multiservice Module User Guide , Issue 1 Release 8.0
Chapter 4 Configuring the Interfaces Using the Console Interface
Managing HDLC Passthrough Interfaces
5 If you need to delete more HDLC interfaces on a port or channel, repeat
steps 1 through 4.
End
Modifying Interface Values
After you have configured an HDLC Passthrough interface for a specified port
and channel, you cannot directly change the parameters for this interface
even if it is out of service. The concept for “modifying” (replacing) an HDLC
Passthrough interface is that you delete the interface with the parameters
you no longer want for a specified port and channel, and then configure a
new interface for the same port and channel. Perform the following proce-
dures in the sequence shown to replace an HDLC Passthrough interface that
has parameters you do not want.
Begin
1
On the Equipment Configuration window, select the module for which
you want to replace an interface.
2
Select the port and channel for the interface you want to replace.
3
View the parameters of the interface you do not want to be sure you are
choosing the right one. See the procedure in the section, “Viewing the
Parameters for an HDLC Passthrough Interface.”
4
Take the interface out of service. See the procedure in the section, “Tak-
ing One or More HDLC Passthrough Interfaces out of Service.”
Note:
After you perform this procedure, the traffic flow on the connec-
tion using the interface is stopped.
5
Delete the interface. See the procedure in the section, “Deleting One or
More HDLC Passthrough Interfaces.”
Note:
After you perform this procedure, the connection using the
interface is automatically deleted from the connections database.
6
Configure a new interface. See the procedure in the section, “Configur-
ing an HDLC Passthrough Interface.”
7
Bring the newly configured interface into service. See the procedure in
the section, “Bringing One or More HDLC Passthrough interfaces into
Service.”
Note:
You now need to provision a new connection using the newly
configured interface for the same specified port and channel for
which you deleted the original interface (and connection). (See
the
PacketStar PSAX System Connections Provisioning Guide for more
information.)
End