LSI Mylex PCI Disk Array Controllers Driver, Installation Manual

Page: 82 / 104

Installing Solaris Using the Mylex MDAC Supplemental Driver Diskette
7-6 PCI Disk Array Controller Drivers Manual
The install.sh script searches for all new or updated drivers on the
diskette. When a new or updated driver is found, the following message
is displayed:
Installing package MYLXmdac
At the bottom of the screen, you will see the following message:
Installation of <MYLXmdac> was successful.
7. When you’re done and the install.sh script exits, unmount the diskette
by typing the following command lines:
# cd /
# umount /mnt
8. Remove the Mylex Supplemental Driver diskette from the disk drive.
9. Reboot your computer, type in the following command lines.
# touch /reconfigure
# reboot
10. Turn off your computer, add the new hardware, and turn on your
computer again.
11. When the autoboot sequence prompt is displayed, quickly press
Escape.
The autoboot sequence is interrupted. The Solaris Device
Configuration Assistant screen is displayed.
12. Press F2 to continue.
You will see the Bus Enumerating screen with the following message:
“Determining the bus and gathering hardware
configuration information” is displayed.
The Scanning Devices screen is then displayed. System devices are
scanned. When scanning is complete, the Identified Devices screen is
displayed.
13. Press F2 to continue.
You will see the following message:
Message: “Loading driver com.bef...” is displayed.
The boot Solaris screen is then displayed.