LSI Mylex PCI Disk Array Controllers Driver, Installation Manual

Page: 21 / 104

NetWare
Manual No. DB11-000030-00 2-7
2
N
E
T
W
A
R
E
6. Select modify | Storage Adapters .
7. Press Ins to add a new driver.
8. Press Ins again to add an unlisted driver.
9. Insert the Mylex Software Kit distribution diskette containing the
NetWare driver into A:\.
10. Press Enter to specify that the driver should be added from the A:\
drive.
The driver is installed. Upon completion you should see the
MDACFSI.HAM driver name and the Mylex controller name listed.
11. Repeat Steps 6 and 7 if you have additional Mylex controllers to install.
Instead of installing the driver again from the diskette, select the
MDACFSI.HAM driver from the driver list for each additional Mylex
controller you are installing.
12. Select return to driver summary. Under the storage adapters screen,
MDACFSI.HAM should be listed.
13. Select continue. Wait while the driver is loaded.
14. Follow the on-screen instructions to finish NetWare 5.1 installation.
Installing NetWare and the Mylex Controller Driver if Not
Booting from the NetWare 5.1 CD-ROM
If you are unable to or choose not to install NetWare by booting from the
NetWare 5.1 CD-ROM, you must create and format a DOS partition on your
hard drive before beginning NetWare installation.
Use the NetWare Bootable License Diskette or MS-DOS 6.00 to create and
format a bootable DOS partition. NetWare recommends a minimum of 50
MB partition size or larger, if space is available.
Installing NetWare 5.1 Drivers (Not Booting from CD-ROM)
Drivers provided in the \DOS subdirectory of the Mylex Software Kit
distribution diskette (packaged with the Mylex Disk Array Controller) are
required to install NetWare 5.1 from a CD-ROM drive connected to a Mylex
Disk Array Controller.
The procedure below assumes that the CD-ROM drivers are available.