LSI Mylex PCI Disk Array Controllers Driver, Installation Manual

Page: 73 / 104

UnixWare
Manual No. DB11-000030-00 6-3
6
U
N
I
X
W
A
R
E
Creating a Driver Diskette for UnixWare
Before installing the Mylex Disk Array Controller Drivers for UnixWare,
a UnixWare driver diskette must be created according to the instructions in
Appendix A, “Creating PCI Driver Installation Diskettes.”
This diskette will be used in both the primary and secondary installation
processes and when updating a previously installed driver wherever
instructed to insert the “Software Kit UnixWare (dak) driver diskette.”
Installing the Controller as the Primary UnixWare
Controller with UnixWare 7.1
If the Mylex Disk Array Controller will be the primary (bootable) controller,
follow the instructions below.
1. Follow the instructions in the appropriate Mylex Disk Array Controller
manuals to set up the hardware, install the controller, connect the disk,
tape, and/or CD-ROM drives, and run the Mylex Disk Array Controller
Configuration Utility to create Drive Groups and System Drives.
☛
Note
CD-ROM or tape drives may be connected to any
channel on the first controller. Do not set the SCSI ID
of either CD-ROM drives or tape drives to ID 0.
2. Initialize all the System drives using the RAID EzAssist Configuration
Utility.
3. Boot the system from the UnixWare Diskette.
4. Follow the instructions provided in the UnixWare Installation
Handbook. The Mylex Disk Array Controller driver for UnixWare is
included on the Software Kit UnixWare (dak) driver diskette which was
made from the Software Kit CD-ROM.
• During the installation, you will be prompted to either Install Host
Bus Adapter Drivers or Continue Installation.
• Select Install Host Bus Adapter Drivers.