LS 47200001, User Manual

Page: 116 / 200

Chapter 9 P2P
9-1
Chapter 9 P2P
9.1 Introduction
P2P can be simply used with sending/receiving device area and data size setting in XG5000.
There are features of P2P as below.
(1)
P2P block setting:
(a) If the TRX areas are many, the block can be set up to maximum 64.
(b) Maximum 244 byte per block.
(2)
Setting of P2P function:
User can set the data sending/receiving direction or diagnostic function.
(3)
Setting of condition flag:
User can set the communication operating condition of each block.
(4)
No. of variable:
User can set the number of sending/receiving data through P2P communication.
(5)
Destination station no.:
User can set the station number of slave module that is going to communicate with.
(6)
Variable setting:
User can set the read area of sending data or save area of receiving data.
1) P2P communication is required the DPv1 to both master and slave module.
Remark