LS 47200001, User Manual

Page: 122 / 200

Chapter 9 P2P
9-7
7) Setting of P2P block
Set the P2P function, condition flag, data type, no. of variable, destination station, destination station
number, variable setting contents in P2P
[Figure 9.4.5] Setting of P2P block
Items Description
Index 0~63 P2P setting blocks are available
P2P function Data WRITE/READ or DIAGNOSTIC
Condition flag Trigger of sending communication frame
Data type Only [Byte] unit is available with P2P
No. of variable It is fixed as 1
Destination station Check to appoint the destination station or not
Destination station
number
Set the station number of slave
Setting
Read area Data address of sending data
Save area Data address of receiving data
Slot Slot of slave module (DPV1 specification)
Index Index of slave module (DPV1 specification)
Data size Size of data that is going to communicate
Variable setting
contents
This field shows the contents that user has set
[Table 9.4.4] P2P block setting
Remark
P2P function
1) WRITE function; writes the data of master to arbitrary address of slave when the condition flag
has been turned on
2) READ function; reads the arbitrary address of slave and saves to set area of master when the
condition flag has been turned on
3) DIAGNOSTIC function; reads the diagnostic information of P2P