LS ELECTRIC XGL-PSEA, User Manual

Page: 16 / 154

Chapter 1 Overview
1-3
1.2 Characteristics of Product
1.2.1 Characteristics of Pnet remote I/F module
The characteristics of Pnet remote I/F module are as follows.
(1) Product design based on International Electrotechnical Commission (IEC 61131) (GLOFA series in common)

Easy support to programming device

Standard language (IEC 61131-3) provided (IL / LD / SFC)
(2) Open network by selecting international standard communication protocol.
(3) Available to communicate with remote master module
(4) Available to set maximum 99 stations.
(5) Enables to save the cost for installation and maintenance.
(6) Various system configuration and simple maintenance and repair.
(7) Easy to change the system.
(8) Compatible with other maker’s product.
- Available to connect Pnet remote I/F module to other maker’s master.
(9) Easy to set the system by hardware station address setting
(10) Simple communication programming.
- Using the GMWIN/KGLWIN High-speed link parameter
(11) Supports various I/O.
- DC input 8/16/32/64 points, TR output 16/32/64 points, Relay output 8/16 points
- Combined 32 point (DC input 16 point/ TR output 16 point)
- Various special module such as AD(analog input)/DA(analog voltage output)/DC(analog current output)
/RTD(Resistor temperature detector)/TC(Thermocouple)
(12) Easy to configure system and use
- Various I/O configurations by user
(13) Provides the online network status detection function.
- Available to know the remote module status through high speed link monitor.
- Available to check diverse module instantly.
(14) High seed communication
(15) Flexible communication relation is available as the speed shall be set automatically according to the speed of master.
(16) Hot-Swap function available
1) Available to change the module during RUN mode.
- I/O modules except the module under change operate normally.
2) Before change, informs the BPMC of module change by switch manipulation.
3) After change, restore the mode switch.
4) You can check the invalid module installation and replacement through operation of M_CHECK,M_CLO/SE at BPMC I/F
program.
P
O
W
E
R
Pnet
remote
I/F
module
DI/DO DI/DO DI/DO DI/DO A/D A/D A/D A/D D/A D/A D/A
SLOT
S0 S1 S2 S3 S4 S5 S6 S7 S8 S9 S10
D/A
S11
Backplane Bus : Expansion I/O module scan (M_CLOSE,M_CHECK)
Changing module during RUN mode
Normal Normal
Checking module
detachment by BPMC
’
s
module check
Before changing, turn on the mode switch