LS ELECTRIC XGL-PSEA, User Manual

Page: 24 / 154

Chapter 1 Overview
1-11
1.6 Notice in Using
When installing this device, notice the followings for the reliability and safety.
Category Classification Contents
Temperature
Condition
•
When installing this device, maintain the temperature between 0~55
°
C
•
Do not exposure it to direct light.
Measure
•
When temperature is too high, install pan, air-conditioner and when temperature is
too low, install suitable device.
Condensing
Condition
•
No condensing allowed.
•
Install something in the control panel for protection from the water and dust.
Measure
•
Due to the frequent On/Off, condensing may occur. In this case, turn on the device
at the night
Shock
Condition
•
Install it in the place where impact and vibration don’t occur..
Measure
•
When impact and vibration is severe, install anti-vibration rubber so that vibration
and impact doesn’t affect the device.
Gas
Condition
•
Install in the place where there is not corrosive gas.
Measure
•
When corrosive gas enters, plan air-purification measure in the control panel.
EMC
Environment
Condition
•
Install in the place where electro-magnetic wave is not severe.
Measure
•
In case of wiring, set the precise route.
•
Check the shield of control panel
For light, use glow lamp and avoid fluorescent lamp
•
When installing power module, ground the device at standard electric potential