41
If the solenoids do not activate, there is no communication between the computer and the
interface. Check that the serial/USB cable is connected properly. Try another serial/USB
cable to verify the cable is not faulty.
There are irregularities in the advancement of the next pick
Probable cause:
•
Misalignment of the magnet
You need to re-adjust the location of the magnet a bit on the knife bar and you can adjust the
position of the knife bar (see adjusting the knife bar in the loom instructions).
Solenoids do not extend far enough
If it is just critical, unscrew the screw heads that protrude at the inside of the dobby hooks
half a turn.
Otherwise, remove a washer from the connection of the interface and the loom at both sides.
Take the ones in between the interface and the knurled nut. This will position the box closer
to the dobby hooks.
Contact
If you still have a problem after reading this section, please contact your dealer or Louët
directly. For problems with the electronic interface you can contact Louet North America.
Louët BV
Kwinkweerd 139
7241 CW Lochem
The Netherlands
Phone: + 31 (0)573-252229
Fax: + 31 (0)573-253858
Email: [email protected]
Website: www.louet.nl
Louet North America
3425 Hands Rd
Prescott, ON, Canada
K0E 1T0
Phone: 613-925-4502 / 1-800-897-6444
Fax: 613-925-1405
Email: [email protected]
Website: www.louet.com
Summary of Contents for Megado 110
Page 2: ......
