13
Take the cloth beam out of Box C. Slide the ratchet wheel over the long shaft and install with
the four 4 x 30 mm screws. Make sure the countersunk holes for the screws are facing out so
that the screw heads fit.
Slide the cloth advance handle over the
shaft against the ratchet wheel and
install the cloth beam into the slots in
the side rails of the loom.
Attach the beam cords to the screw
heads of the cloth beam and the warp
beam.
The Texsolv cords are cut at a joint
between two loops. As a result, the end
loop of a cord is not strong. Therefore
attach the cords, using the second-to-
the-end loop, over the screw heads of
the cloth and warp beam.
9. The brake on the warp beam
Turn the screw eye into the right back
post until only the eye protrudes. Use
the screwdriver as a lever.
Summary of Contents for Megado 110
Page 2: ......
