23
Replace washer and nut onto the
threaded rod that now protrudes under
the side rail. Tighten nut and cap nut
securely using two 13 mm wrenches
and then remove the book(s).
A spring and a cord are attached to the
screw eye in the blocking block. The
cord has to be attached to the dobby
treadle. The spring has to be attached
to the middle post and will, by pulling
the cord through, bring the dobby
treadle in its highest position.
Guide the cord through the eyelet on
the bottom of the treadle and attach
onto the plastic hook.
Take one of the screw hooks and
screw it into the pilot hole on the middle
post. Loop the eye of the spring around
the hook.
Guide the cord over the pulley above
the treadle.
When you push the dobby treadle down, the blocking block turns under the treadle for the
shed and consequently prevents this treadle from moving. When you push in the treadle for
the shed, the blocking block cannot be turned, so it prevents the dobby treadle from moving.
Adjust the position of the blocking block by turning the knurled nut at the bottom of the dobby
treadle and/or altering the cord loops on the plastic hook. By shortening the cord, you will
reduce the space between the blocking block and the depressed shed treadle. This space
should be about 3/8" (1 cm).
Summary of Contents for Megado 110
Page 2: ......
