REMOTE OPERATION
Logicube EchoPlus-
NG User’s Manual
64
a.
Open
Control Panel
and select either
Programs & Features
or
Programs
.
b.
Click
Turn Windows features on or off
. If a prompt for an administrator password or
confirmation, type the administrator password or provide confirmation (A Network or
Systems Administrator may be required for administrator access).
c.
In the Windows Features dialog box, select the Telnet Client check box.
d.
Click OK. The installation might take several minutes.
Once the Telnet client is installed, follow the steps below to connect using the Windows Telnet
client.
1.
Connect the EchoPlus-NG to the network by attaching a network cable to the RJ45
connector in the back of the EchoPlus-NG.
2.
Turn the EchoPlus-NG on and allow it to boot up completely.
3.
Open the Telnet client.
4.
Type
open
followed by the IP address or name of the -NG. For example,
open
192.168.1.100
or
open EchoPlus-NG-XXXXXX
where XXXXXX is the 6-digit serial number
of the EchoPlus-NG, then press Enter. The EchoPlus-NG login screen should appear.
Note:
On some Operating Systems, the EchoPlus-NG will need to be accessed by
opening EchoPlus-NG-XXXXXX.local.
5.
Login with the username “
it
” (without the quotes) and the password “
it
” (without the
quotes).
6.
A prompt should appear on the Telnet window.
7.
The EchoPlus-NG can now be configured or managed via the command line interface.
8.5 Zero Configuration Networking (Zeroconf)
The EchoPlus-NG has the capabilities for Zero Configuration Networking (Zeroconf). Zeroconf
allows devices to automatically create a usable computer network based on the Internet
Protocol Suite (TCP/IP).
For example, when the EchoPlus-NG is connected (connected via a network cable) directly to a
Windows based computer that is DHCP enabled, both the EchoPlus-NG and the Windows based
computer will automatically configure themselves to be seen by each other using TCP/IP.
8.6 Configuring the EchoPlus-NG with a static IP address
The EchoPlus-NG is DHCP enabled by default. Some networks do not support DHCP and require
a static IP address. The EchoPlus-NG can be configured with a static IP.
