TYPES OF OPERATIONS
Logicube EchoPlus-
NG User’s Manual
46
1.
Turn the EchoPlus-NG off then back on. This will reset all settings to its
default configuration. This is an important step to help ensure only the
changes desired will be the changes saved.
2.
Connect a drive to the SATA_M master SATA port.
3.
Go to the
Clone
screen and set the Master drive to
SATA_M
.
4.
In the
System Settings
, go to
Profiles
and tap the
New
icon
5.
Type a name for this profile. For example, SATAMASTER and tap the
OK
icon. The profile name should appear on the screen.
6.
Tap the newly saved profile and tap
Save
. A confirmation screen will
appear.
7.
Tap the
Yes
icon to save the profile.
8.
Make sure the profile to be loaded (during the boot process) is
highlighted (in this job, SATAMASTER.DB) and tap the
Load
icon. A
confirmation screen will appear.
9.
The next time the EchoPlus-NG is turned on it will load SATAMASTER
profile. Also, each time a profile or configuration is selected, then
loaded, it will immediately load the saved settings on that profile or
configuration.
To delete a profile, tap the
delete
icon. A confirmation screen will appear. Tap
the
Yes
icon to delete the selected profile.
It is highly recommended that the EchoPlus-NG is turned off then
back on before making any changes to a profile. This helps ensure
that only the desired changes are saved.
5.6.2 Passwords
There are two sets of passwords that can be entered on the EchoPlus-NG.
Log File Deletion Password –
A password can be set as an extra layer of
protection when deleting log files. If this password is set, EchoPlus-NG
will prompt for the password before any log files can be deleted.
Config Lock –
The
EchoPlus-NG can be configured to lock out any
configuration changes. When this is enabled, changes to the different
types of operations cannot be made without entering the correct key or
password. Operations like Clone, Hash, or Wipe can still be started.
For example, when the EchoPlus-NG is locked, and it is configured for
Drive to Drive clone mode, the user will be unable to change this mode
to Drive to Image or Image to Drive, but can start the Drive to Drive
task.
