CLONE
Logicube EchoPlus-
NG User’s Manual
29
When attempting to clone to a Target drive that is smaller in
capacity than the Master drive, the partitions on the Master drive
need to be adjusted to be no more than the same size of the
Target drives. Please see
Section 3.1.2
for more information on
cloning to smaller capacity drives.
If Mirror was chosen, a screen will appear showing a
percentage of the Master drive to copy. By default, it
will be set to 100% to copy the entire Master drive.
Tap
Mirror Settings
to bring up the
Mirror Clone
Advanced Settings
window. This screen displays an
option to select whether the Master drive is a RAID
configuration or a NON-RAID configuration. There are
also 3 other parameters that can be set:
LENGTH –
Sets the percentage or number of
blocks to clone.
MASTER START –
Sets the percentage or
number of blocks from the start of the Master.
TARGET START –
Sets the percentage or
number of blocks from the start of the
Target(s).
To enter an LBA number (number of blocks),
press and hold one of the left or right arrows on
the Length, Master Start, or Target Start. A
window will appear like the one below allowing
you to enter a specific number of blocks.
4.3.4.3 Cloning Drives from a RAID Array
When cloning drives from a RAID array, ‘Drive to Drive’ and
Mirror mode must be used. The EchoPlus-NG can check the
Master drive to see if it has a RAID configuration. When the
RAID
icon is selected, the EchoPlus-NG will check the Master
Drive for a RAID configuration, and check the Target drive.
RAID information is
NOT
copied or cloned to the Target drive.
When cloning a Master drive from a RAID array, the Target drive
may need to be initialized by the RAID controller prior to cloning
for the RAID controller to recognize the drive as part of a RAID
array.
