Safety
10
www.loepfe.com
WeftMaster CUT-iT Dornier
2.3
Target group
The WeftMaster CUT-iT Dornier device may only be operated by authorized personnel. The authorized
personnel is qualified when it completes the necessary training, knows the requirements and is authorized
for the assigned task.
2.3.1
Authorized personnel
The WeftMaster CUT-iT Dornier manufacturer defines authorized personnel as follows:
n
«Operator»
and
«foreman»
– Qualified and trained to operate WeftMaster CUT-iT Dornier.
– Has read and understood the safety regulations.
n
«Industrial electrician / installation technician»
– Qualified and trained for all safety checks and installation, maintenance and service guidelines.
– Responsible for WeftMaster CUT-iT Dornier installation and maintenance.
– Has read and understood the safety regulations.
n
«Service technician»
– Loepfe employee qualified and trained for maintenance and repair of the device or persons
authorized with express permission from Loepfe Brothers Ltd.
2.4
General safety information
n
The WeftMaster CUT-iT Dornier and the heat cutters may only be installed by an
«industrial
electrician / installation technician»
or
«service technician»
.
n
Read all the safety and installation instructions before installation or maintenance.
n
Keep the complete documentation for later reference.
n
Observe all warnings on the device and in the documentation of the weaving machine on which the
device is installed or maintained.
n
Disconnect the weaving machine on which the control unit is installed from the power network before
installation or maintenance.
n
An easily accessible switch identified as disconnecting equipment for the device must be installed in
the fixed wiring of the main power circuit of theWeftMaster CUT-iT Dornier.
– An (emergency) switch must be fitted in the main power circuit to disconnect the device in the
case of an emergency or for service work. In most cases, the main switch of the weaving machine
on which the control unit is fitted is used.
– The power supply of the WeftMaster CUT-iT Dornier must be interrupted when the main switch of
the weaving machine on which the control unit is installed is switched off.
n
After installation, check all covers are closed and protective plates attached before the weaving
machine is started.
n
Any use of the device beyond the intended purpose (see Intended Use [
9]) is considered to be
improper use. In this case, the protection provided by the device cannot be guaranteed.