Product and Function
16
www.loepfe.com
WeftMaster CUT-iT Dornier
The 4 different current flow modes
Mode
Description
Off mode
Output current is switched off.
Display:
«POWER OFF»
(switched off)
Standby mode
Time in which the weaving machine is idle. Predefined current flows
through the cutting wires during this time. This achieves an optimum out-
put temperature for the machine to run.
Display:
«Standby»
Boost mode
Weaving machine starting phase. Predefined current flows through the
cutting wires for a limited time. This current heats the cutting wires as
quickly as possible to operating temperature.
Display:
«Boost»
(startup current)
Run mode
Time in which the weaving machine is running. The predefined current
flows through the cutting wires during this time.
Display:
«Run»
(running current)
The WeftMaster CUT-iT stops the weaving machine in the following cases
n
The power supply is interrupted.
n
A system error is detected.
n
No cutting wire is connected.
n
A cutting wire is broken (defective).
n
A connection cable is interrupted.
n
WeftMaster CUT-iT Dornier restarts.
3.1.2
Heat cutter / cutting wire
1 to 4 heat cutters can be fitted per WeftMaster CUT-iT Dornier control unit at maximum heating output. A
higher number of cutters reduces the performance per cutter.
n
6 different cutter specifications
n
3 cutting wire types are available in different wire sizes of ø 0.5 mm, 0.7 mm, 1.0 mm, 1.2 mm and 1.5
mm. The cutting wire types combined with the strengths can be found in the Spare Parts catalog.
n
Heat cutter and cutting wire specification depend on the fabric material and speed, as well as filling
and warp densities.
