Note
: Use These Instructions for
Standard
Installations
8.
After resetting the UserName and Password to the factory defaults, type
172.21.32.43 and proceed as described in Points 1 through 7 of this Step to
re-configure the LNI 2000 to your new settings, as specified on the work or-
der.
Note: After resetting to the factory defaults, the UserName and
Password are both “admin.”
9.
Disconnect cables when programming is complete. The LNI 2000 is now
ready for repackaging and installation on the customer premises.
Note
: If all three LEDs (Power, IP Link and IP Monitoring) begin
flashing, there is a firmware update in progress. Do not disconnect
any wiring or power down until the update is complete and the LEDs
have stopped flashing. This flashing may continue for several
minutes.
LNI 2000 Installation Manual
39
