Lissmac COMPACTCUT 201 D, Operating Manual

Page: 28 / 84

28/84
NOTICE
Saw blade installation
When installing the saw blade, make sure that the flange surfaces are clean.
The saw blade must be in direct contact with the flange. Use the direction arrow to adjust the direction of
rotation of the saw blade to the direction of rotation of the saw blade shaft (synchronism).
Sequence
The following steps must be followed to install or change the saw blade:
1. Activate the parking brake.
2. Ignition switch to OFF.
3. Remove water hose from blade guard.
4. Release bolt (#1) and open blade guard (#2).
5. Release clamp screw (#3), and remove washers (#4) and thrust washer (#5).
6. Clean all contact surfaces.
7. Put the saw blade on the flange (#6). (Observe direction of rotation – synchronous cutting!)
8. Put the thrust washer and washers into position and tighten with the bolt.
9. Close the blade guard and secure with the bolt.
10. Connect water hose to the blade guard.
Left-hand
thread!
1
2
5
4
3
6