Dive Computer
User Manual
Liquivision Products, Inc
-
59
-
Revision 1.9 Software 1.17
“Battery Savings” mode
In the event that your battery is very low during the dive, your KAON will go into “Battery Savings”
mode. It is a mode that tries to preserve the battery as much as possible, so that the KAON keeps
functioning as long as possible. This mode changes the following things:
•
all the information on the display will turn green (the color that is most power-economical)
•
the display brightness will be set to low
For more details, please refer to
Battery Savings Mode: When Your Battery Voltage Drops Below A
Exiting the water
Once you are shallower than 0.6 meters / 2 feet, your KAON will go back into surface mode and offer
you access to surface menus.
However, for next few minutes, it will remain in post-dive mode. You can control length of this period,
in menu setting
. This means that if you resume your dive within that period,
it will be counted as continuation of previous dive, instead of a new one. This also means, that all the
numbers, such as maximum depth, average depth, dive time, etc. will not be reset.
After that, if you decide to dive again, it will be counted as a new dive.
Last dive information
When on the surface, and not in Sleep Mode, your KAON will display
information about the last dive that you have done.
Surface
– it is time elapsed since your last dive. If it is less than 24 hours, you will see the number of
hours and minutes. If it is more than 24 hours, you will see number of days and hours. If it is more than
10 days ago, you will not see any surface interval.
Last depth
– is the maximum depth of your last dive, with one decimal place. Depending on your unit
settings, it will be either in meters, or in feet, and you will see “m” or “ft” printed after the number.
Last time
– is the total time of the last dive, displayed according to your dive time settings – either as
total number of minutes, or as hours:minutes.
