Link XP L2102/L2104 Receiver Instruction Manual Issue 1 - October 2003 Page 30 of 48
Link Research Ltd. 23/24 Watford Metro Centre, Dwight Road, Watford, Hertfordshire, WD18 9XA, England. Tel: +44 (0) 1923 200 900
Registered in London No. 2074604
Web:
www.linkres.co.uk Fax: +44 (0) 1923 241 357
L2102 & L2104 Receiver
Instruction Manual
Default values are shown in
bold. #
indicates a value derived from the setting or
entered by the User.
Top level
menu
Sub menu
Options
Comments
Status
None
None
Bar graph like display for each RF
input indicating received packet
quality. The nearer the display is to
the right, the greater the number of
good packets received. It is very
common for the display to fluctuate
widely and the receiver will operate
correctly with very low status values.
Config 1
Stores the current settings into
memory location 1.
Config 2
Stores the current settings into
memory location 2.
Config 3
Stores the current settings into
memory location 3.
Config 4
Stores the current settings into
memory location 4.
Config 5
Stores the current settings into
memory location 5.
Config 6
Stores the current settings into
memory location 6.
Config 7
Stores the current settings into
memory location 7.
Config 8
Stores the current settings into
memory location 8.
Store – Config?
Config 9
Stores the current settings into
memory location 9.
Config 1
Loads stored settings from memory
location 1.
Config 2
Loads stored settings from memory
location 2.
Config 3
Loads stored settings from memory
location 3.
Config 4
Loads stored settings from memory
location 4.
Config 5
Loads stored settings from memory
location 5.
Config 6
Loads stored settings from memory
location 6.
Config 7
Loads stored settings from memory
location 7.
Config 8
Loads stored settings from memory
location 8.
Load – Config?
Config 9
Loads stored settings from memory
location 9.
No
Does not change the current active
settings.
Memory
Default Restore No
Yes
Restores the current active settings
to factory defaults.
NB – If the receiver cannot be set up,
it is worth using this option and then
restarting the set-up again.
