-19-
＜
Example of LSB first
＞
＜
Example of MSB first
＞
ڦ
DLE code
Set a DLE code in HEX for transparent mode. As a factory setting, “10h” is already set.
ڦ
Bit sequence
Set a bit sequence. For general protocols, select “LSB first”.
ڦ
Frame end time
Set the time of non-communication state which is judged as a frame end at between 1ms and 100ms.
Initial value is 5ms.
This setting is necessary to record time stamp.
Set the frame end time to be smaller than idle time.
ڦ
Frame end code
Set a frame end code (1 or 2 characters) in HEX.
Initial setting is
“
blank”. If setting nothing in here, frame end is judged by “Frame end time”.
〇
SYNC
・
BSC (Character SYNC)
ڦ
Data code
Same as ASYNC.
ڦ
Data bit
Set a data bit length. Only the bit length allowed for each data
code can be set.
Total bit of data bit and parity should be 6 or 8.
9.4 Data Code Chart
ڦ
Parity
Set a parity bit.
ڦ
Clock
Select a SYNC-clock to receive/transmit communication data. Select “AR” if the SYNC-clock is uncertain or
using the RS-422/485 port which has no clock line.
9.2 Send/Receive Clock
MARK State
Character Bit
LSB
Start Bit
MSB
Parity Bit
Stop Bit
~ ~
~ ~
Character Bit
LSB
Start Bit
MSB
Parity Bit
Stop Bit
MARK State
~ ~
~ ~
