4. Installation
series – Extender Application Mode – User's Manual
31
4. Installation
series – Extender Application Mode – User's Manual
31
EXTENDER APPLIC
A
TION MODE
Applied F-series endpoint firmware package: v2.0.0 | Applied R-series endpoint firmware package: v2.0.0 | LDC software: v2.5.9b3
4.1. Mounting Options - F-series Endpoint Devices
Devices can be mounted in several ways, depending on the application. Besides using with rack shelf, a
mounting bracket is available which offers easy mounting on truss systems with standard clamps. The
bracket can be also used for building the unit into the furniture:
Mounting bracket V2
1U high rack shelf
WARNING!
Always use the supplied screws. Using different (e.g. longer) ones may cause damage to the
device.
ATTENTION!
Pay attention to the ventilation holes when designing the system especially when the
extender is built into/under furniture. Front and rear ventilation holes must not be covered. If a UBEX device
is installed in a closed space, the designer shall provide satisfactory ventilation to prevent excessive heat
build-up inside.
INFO:
The endpoint device is half-rack sized.
To order mounting accessories please contact
4.1.1. Mounting Bracket V2
Mounting bracket V2 gives an opportunity to mount the device to any furniture surface. Fasten the bracket
on the side of the unit with the provided screws and fasten it to a stand / board / truss / furniture.
Fixing the Bracket to the Device
Fasten the mounting bracket on the side of
the unit with the provided screws (4 pcs M3
screws per Mounting bracket V2).
WARNING!
M3x6 size is the longest allowed screw for fixing the ears to the housing. Using different
(e.g. longer) ones may cause damage to the device.
Furniture Mounting
WARNING!
Pay attention to the ventilation holes when designing the system. Front and rear ventilation
holes must not be covered.
INFO:
The chipboard screws are not supplied with the mounting kit.
4.1.2. Rack Shelf Mounting
Allows rack mounting for half-rack,
quarter-rack and pocket sized units.
1U high rack shelf provides mounting
holes for fastening two half-rack or
four quarter-rack sized units. Pocket
sized devices can also be fastened
on the self.
WARNING!
Pay attention to the
ventilation holes when designing
the system. Front and rear
ventilation holes must not be
covered.
INFO:
The screws for the rack
frame are not supplied to the
device.