Lightmed TruScan 532, Service Manual

Page: 47 / 140

Multi-Wavelength Pattern Scanning System - LightLas 532 / 670 - Service Manual Page 47 Rev. No 01
3. Reset the emergency pushbutton by unscrewing outward position
4. Initial the console power by turning the key switch
5. Verify if the system passes the self-checking mode (refer to fig. 4.20a-c) if not,
proceed to troubleshooting section otherwise proceed to next step
6. Initial the aiming intensity verification test (refer to fig. 4.21)
6. Ensure the safety filter is installed prior trigger and fire the laser
7. Check the output power of the system and ensure it is met the specification
requirements according to the section 7.3 of this manual
Figure 4.20(a) System boot up sequential display
1
Figure 4.20(b) System boot up sequential display
2
Figure 4.20(c) System boot up sequential display
3 Figure 4.21 Initial Aiming Intensity Verification