Lightmed TruScan 532, Service Manual

Page: 31 / 140

Multi-Wavelength Pattern Scanning System - LightLas 532 / 670 - Service Manual Page 31 Rev. No 01
9. Glide the delivery housing with Truscan module integrated until it reaches to the
chrome stopper and gently secure the screw (refer to fig. 4.11a-b)
10. Mount and secure the chinrest ass’y and ensure all the connections are plug in
including slit lamp and fixation lamp power source connectors (refer to fig. 4.12)
11. Clamp the fiber support arm to the chinrest ass’y and gently position the
delivery fiber to the Truscan aperture (refer to fig. 4.12)
12. Hang the console unit and plug in all the connections including joystick, interlock
plug, footswitch receiver plug, scan delivery, power cord, delivery fiber, slit lamp
delivery key plug, and power switch key (refer to fig. 4.13a-b)
13. Position the arm rest and readjust if applicable (refer to fig. 4.14)
14. Mount the LCD panel holding arm by clamp down to the table top (refer to fig.
4.15a)
15. Load the LCD panel to the arm by fasten the four screws located at the rear of
panel and plug in all the appropriate connectors (refer to fig. 4.15b-c)
Note: Do remember the 9 pins connector is connected to COM
1
only
16. Power on the LCD control panel and await for the system to boot up correctly
then key switch the console power to establish communication with console
system (refer to fig. 4.16a-b)
17. Proceed to the operation section of guideline once completed preliminary
installation and rechecking process
Figure 4.7 Slit lamp Packaging Ass’y
Binocular
Lower Base Housing
Upper Arm Housing
Chinrest Ass'y
Delivery Housing with
Truscan Integrated
Dust Cover / Accessories