Lightmed TruScan 532, Service Manual

Page: 25 / 140

Multi-Wavelength Pattern Scanning System - LightLas 532 / 670 - Service Manual Page 25 Rev. No 01
A. System table top / motorized stand
The table top and motorized stand are ready to use system therefore minimize
installation is required. Prior to install the table top ass’y and motorized stand,
ensure all the equipment are in placed to before proceeding to the installation steps.
Caution: The table top and motorized stands are very heavy therefore an assistant
may require to the installation process
System part(s):

Table top

Motorized stands

Power cord

Accessories
1. Unpack the table top, motorized stands, and accessories from the box and
prepare and allocate them near the installation site
2. Lay the table top ass’y and motorized stands on the floor with protection layer
carefully
3. Place the left stand near the metal plate with power switch facing outward and
slowly tilt and plug in the inter-power connectors (refer to fig. 4.3), and then
fasten the eight bolt nuts using packed insert allen key
4. Repeat the above step with right stand
Note: The power connections need to be facing each other (refer to fig. 4.4)
5. Ensure the correct voltage setting is set correctly; as default setting is set at
230VAC (refer to fig. 4.5a-d)
6. Unpack the console bracket holder and fasten it against the table top with the
eight screws
7. Ensure the all the bolt nuts are fasten secure prior to roll up
Caution: You may need an assistant to roll up the fully assembled Multi-
Wavelength Pattern Scanning System - LightLas 532 / 670 table’s system
8. Move the assembled table system to the final destination and ensure the table is
well leveling
9. Plug in the power source to a wall outlet and test run if table will lift up / down
and the slit lamp power switch is lit when switching 'ON' (refer to fig. 4.6)
10. Lock the wheel stopper before proceeding to the next installation steps