LifeSize Gateway-PRI, User Manual

Page: 74 / 196

66 LifeSize Gateway User Guide
Configuring Gateway Settings
C
ONFIGURING THE
G
ATEWAY FOR
P
EER
-
TO
-P
EER
IP
C
ONNECTIVITY
In the IP Connectivity section of the Settings tab, you can configure the
LifeSize Gateway for peer-to-peer IP connectivity.
Procedure
1
In the LifeSize Gateway interface, on the sidebar, click
Gateway (if not already selected).
2 Click the Settings tab.
3
Click the IP Connectivity button.
4 In the IP connectivity mode field, choose Peer-to-Peer .
Note Changing this setting causes the LifeSize Gateway to reset.
5 In the Peer hunting mode field, choose one of the following
options:
Always start from first peer —The LifeSize Gateway
attempts to connect a call to the first peer device on the
Peer list section. If the call fails due to one of the
H.323 call disconnect reasons (see About Peer-to-Peer
H.323 Call Disconnect Reasons on page 69), the
LifeSize Gateway tries each peer device in the Peer
list section in order until the call is successfully
connected. If the LifeSize Gateway fails to connect the
call after trying all the peer devices on the list, it rejects
the call.
Always start from last successful peer —The
LifeSize Gateway attempts to connect a call to the last
peer device in the
Peer list section with which a call
was successfully established. An arrow in the Peer list
section indicates with which of the peer devices a call
was last connected successfully. If the call fails due to
one of the H.323 call disconnect reasons (see
About
Peer-to-Peer H.323 Call Disconnect Reasons on
page 69), the LifeSize Gateway tries each peer device
in the
Peer list section in order until the call is
successfully connected. The arrow moves to the peer
device with which the call connection is successful. If