LifeSize Gateway-PRI, User Manual

Page: 142 / 196

134 LifeSize Gateway User Guide
Configuring Gateway Maintenance Tasks
UDP-in-datagram counter —Displays the number of User
Datagram Protocol (UDP) packets received.
Packet loss counter —Displays the number of lost packets.
Packet late counter —Displays the number of late packets.
(Gateway-PRI only) Accumulated time of B channel usage —
Displays the total B channel usage (in minutes).
Counter reset time —Displays the last time at which the counters
were reset.
Reset Counters button—Click to reset all counters to zero.
C
ONFIGURING
G
ATEWAY
M
AINTENANCE
T
ASKS
In the Maintenance tab, you can enter maintenance mode. In maintenance
mode, you can perform maintenance work on the LifeSize Gateway, such as
upgrading software. In maintenance mode, the LifeSize Gateway cannot accept
new calls. You can disconnect all calls currently active in the LifeSize Gateway,
or wait for them to disconnect. In maintenance mode, you can only modify the
following configuration settings:
Services (see About Gateway Services on page 103 for more
information)
Fractional B channel status (Gateway-PRIs only) (see Viewing B
Channel Status on page 61 for more information)
Gatekeeper IP connectivity (see Configuring IP Connectivity
Settings on page 63 for more information).
Resource allocation
IVR (see Configuring IVR Settings on page 70 for more information)
To enter maintenance mode, click Enter Maintenance Mode . To exit
maintenance mode, click Exit Maintenance Mode .
S
AVING
C
ONFIGURATION
S
ETTINGS
You can save LifeSize Gateway configuration settings to a file and then export
this file to a storage device on your network. You can use the saved
configuration file to restore the settings to the current LifeSize Gateway unit or
to configure a similar LifeSize Gateway unit.
An exported configuration file saves most of the current Device section settings
and all of the current Gateway section settings.
Note
You cannot save configuration settings in the System category.