LifeSize Gateway-PRI, User Manual

Page: 99 / 196

Configuring the LifeSize Gateway 91
Configuring Gateway Settings
3
Click the Advanced button.
Table 3-12 explains the IP-to-ISDN (or Serial) call settings you
can configure in this section.
Table 3-13 explains the ISDN (or Serial)-to-IP call settings you
can configure in this section.
Table 3-14 explains the IP call settings you can configure in this
section.
Table 3-15 explains the ISDN call settings you can configure in
this section (available in Gateway-PRI only).
Table 3-16 explains the general call settings you can configure
in this section.
Table 3-12 Advanced Settings—IP to ISDN (or Serial) Calls
Field or Check Box Description
Conceal caller ID
(unavailable in
Gateway-Serial)
Select to have the LifeSize Gateway hide the identifier of
the calling endpoint on the IP network, regardless of
whether the
Support Presentation Restriction advanced
setting is selected. The callerID field of the Q.931 message
is sent over the ISDN network empty.
Ignore caller bearer rate
and force service rate Select to configure the LifeSize Gateway to ignore the
incoming call bearer rate and to use instead the bandwidth
specified for the service in the
Services tab to process the
call. If the service bit rate is set to Auto , the LifeSize
Gateway process the call at the bearer rate.
Deselect to allow an administrator to limit a specific service
to a maximum bit rate. When deselected and the bearer rate
is greater than the service rate, the LifeSize Gateway
processes the call at the service rate. When deselected and
the bearer rate is lower than or equal to the service rate, the
LifeSize Gateway processes the call at the bearer rate. If the
bearer bit rate is set to
Auto , the LifeSize Gateway process
the call at the bearer rate.