LifeSize Gateway-PRI, User Manual

Page: 134 / 196

126 LifeSize Gateway User Guide
Configuring Port Settings
Click Configure .
The NSF Configuration dialog box appears. You can
configure up to four NSF information elements.
Note You can only configure the NSF information elements (NSF IEs) if
you set the Interface field in the Physical Interface section of the PRI Port
tab to T1 and set the Country field to US . All outgoing Q.931 setup messages
will contain the NSF IE.
Select the Enable check box.
In the Octet 3 field, choose a value. When the value is
greater than 0, that number of fields appears beneath
the Octet 3 field. If this field is set to
0 , the Octet 3.1
and Octets 3.2 fields are not available. If this field is
set to
1 , only the Octet 3.1 field is available.
In the Octet field(s), choose settings.
In the Type field, choose Binary feature or Binary
service and then in the Facility Coding Value field,
enter a value.
—or—
In the Type field, choose Parameterized and then in the
Parameterized Field field, enter a value.
—or—
In the Type field, choose Custom and then in the Octet 4
and Octet 5 field (if applicable), enter a value.
Note
When you select Binary feature or Binary service in the Type field,
the Facility Coding Value field is for Octet 4, Bits 5-1. When you select
Parameterized in the Type field, the Parameterized Field field is for Octet
5, Bits 7-1. When you select Custom in the Type field, the values entered in
the Octet 4 or Octet 5 fields are not subject to bit restriction.
Repeat step 1 for as many additional NSF information
elements as necessary.